Product Description
BMW E36 Battery Disconnect Kill - 6 Pole Switch Kit (RECOMMENDED)
The HARD Motorsport complete Battery Disconnect/Kill Switch kit for the E36 comes with everything you need to add a kill switch to your E36. It bolts right in! No extensive fabrication or drilling needed. Wires to your stock harness. The panel mounts into your glovebox opening. Simply remove your oem glovebox and mount our panel in there.
Kit includes:
- Pre-Cut Aluminum panel. Black Cerakote Finish.
- Power cable (cut to length and ended...ready to go!)
- ON/OFF SWITCH w 6-pole 12v battery & accessory disconnect switch with removable key.
- Ground wire (neg) Power Feedback Resistor
- Mounting hardware kit, cables, bolt kit, and heat shrink included
- Installation wiring suggestion link below. Not all wiring is the same, so there is not ONE way to wire a disconnect switch. Review your car’s wiring and make sure your solution cuts main battery power to the chassis as well as killing power to the ECU and the ingnition system. Note: On '92-'95 you may have to run a separate wire to the ignition to cut power to the ECU with key/power off.
Made in the U.S.A.!!!
Right-hand drive option available for those that like to drive on the other side of the stripes! (Special Request)
STANDARD 2-POLE INSTALL
DOWNLOAD PDF
